景德真空泵-真空泵厂家-吉玛泰克(推荐商家)

带端子板的传感器盒

IP66聚苯i乙烯传感器盒。? 可定制的电缆进线和出线，配有标准电缆密封套。? 2个螺钉端子，景德真空泵，可直接连接15个输入/输出 。? 随附铝挤压型材直接固定螺钉。? 每个连接线路的zui大开关电流达1A。

IP66 polystyrene sensor box.? Customizable cable input and output with standard cable gland

2 screw terminals with direct connection of 15 inputs/outputs. ? Supplied complete with direct fxing screws for aluminum extruded profles.

Maximum switching current up to 1A for each connection line.

? 传感器位于后部位置以及抓持区域占用空间更小的新理念。

? 可选磁性传感器 (1)。

? 只有在抓持物品时，真空泵厂家，传感器才打开。

? 带有弹簧开口的单动式驱动器。

? 高抓持力。

? 配有几个安装附件 (2)。

? 钢质颚式钳。

? FDA-H1 食品级润滑脂。

? 防止进入微小异物 (3)。

? 重型末端行程。

2-jaw self-centering angular pneumatic sprue

gripper， series DD

? New concept with retracted sensor and smaller dimensi0ns in

the grip area.

? Optional magnetic sensors (1).

? The sensor is ON only when something is gripped.

? Single acting with spring opening.

? Very high closing force.

? Several mounting accessories (2).

? Steel jaws.

? FDA-H1 food-grade grease.

? Protection against the entry of small foreign bodies (3).

? Heavy-duty end-strokes.

编程单个SB8F

在对传感器盒进行编程之前，请确保有线输入处于所需配置（开/关）以启用输出。按下AUTOSET按钮并按住3秒钟，真空泵大全，直到READING红灯开始闪烁，真空泵品牌，然后松开。红灯（READING）闪烁表示微处理器正在读取和存储全部输入的状态。然后红灯熄灭，启用了输出。黄灯（STORED）指示启用输出。

Before programming the sensor box， make sure that the wired inputs are in the confguration (ON/OFF) desired to enable the output. Press the AUTOSET button and hold it down for  3 seconds until the READING red light starts fashing， then release it.The  red light (READING) fashing indicates that the microprocessor is reading and storing the state of all the inputs. Then the red light goes off and the output is enabled. Output enabling is indicated by the yellow light (STORED).