手动旋转装置-苏州吉玛泰克-青海旋转装置

编程单个SB8F

在对传感器盒进行编程之前，机械旋转装置，请确保有线输入处于所需配置（开/关）以启用输出。按下AUTOSET按钮并按住3秒钟，直到READING红灯开始闪烁，然后松开。红灯（READING）闪烁表示微处理器正在读取和存储全部输入的状态。然后红灯熄灭，启用了输出。黄灯（STORED）指示启用输出。

Before programming the sensor box， make sure that the wired inputs are in the confguration (ON/OFF) desired to enable the output. Press the AUTOSET button and hold it down for  3 seconds until the READING red light starts fashing，青海旋转装置， then release it.The  red light (READING) fashing indicates that the microprocessor is reading and storing the state of all the inputs. Then the red light goes off and the output is enabled. Output enabling is indicated by the yellow light (STORED).

SBMS/SBMS-E - 从模块

每个单独的从模块均可以连接单个传感器。它由内部总线连接（由主模块提供）供电，并触发两个固态继电器的换向：基于传感器输出的常开触点和常闭触点。两个选择器可用于配置传感器信号输出（PNP/2线或NPN）和逻辑（正向或反向）。该模块还有两个用于诊断的LED指示灯。

Each individual slave module enables the connection of a singlesensor.

It is powered from the internal bus connection (provided by themaster module) and triggers the commutation of two solid staterelays: a NO contact and a NC contact based on sensor output.

Two selectors are available to conffgure sensor signal output(PNP/2 wires or NPN) and logic (direct or reverse).The module also has two LED indicators for diagnostics.

吸盘/聚氨酯

VG.BR30X55 聚氨酯矩形波纹管吸盘

? 适用于处理流动包内的快餐食品和食品棒

? 带 1.5 波纹管的版本

? 能够处理较小水平差的物品

? 适用于抓持与表面平行或垂直的应用

? 唇口能够完全适应塑料薄膜

? 是拾取物品并将其放在旁边的理想选择

? 压花的胎面花纹可防止损坏处理的产品以及唇口内爆

技术特征

材料 聚氨酯 PU，50 肖氏硬度 

颜色 蓝色

硬度 50 Shore

温度范围 +10 - +45 °C