舟山机器人抓手-苏州吉玛泰克-机器人快换抓手

? 传感器位于后部位置以及抓持区域占用空间更小的新理念。

? 可选磁性传感器 (1)。

? 只有在抓持物品时，传感器才打开。

? 带有弹簧开口的单动式驱动器。

? 高抓持力。

? 配有几个安装附件 (2)。

? 钢质颚式钳。

? FDA-H1 食品级润滑脂。

? 防止进入微小异物 (3)。

? 重型末端行程。

2-jaw self-centering angular pneumatic sprue

gripper， series DD

? New concept with retracted sensor and smaller dimensi0ns in

the grip area.

? Optional magnetic sensors (1).

? The sensor is ON only when something is gripped.

? Single acting with spring opening.

? Very high closing force.

? Several mounting accessories (2).

? Steel jaws.

? FDA-H1 food-grade grease.

? Protection against the entry of small foreign bodies (3).

? Heavy-duty end-strokes.

编程单个SB8F

在对传感器盒进行编程之前，机器人吸盘抓手，请确保有线输入处于所需配置（开/关）以启用输出。按下AUTOSET按钮并按住3秒钟，直到READING红灯开始闪烁，然后松开。红灯（READING）闪烁表示微处理器正在读取和存储全部输入的状态。然后红灯熄灭，舟山机器人抓手，启用了输出。黄灯（STORED）指示启用输出。

Before programming the sensor box， make sure that the wired inputs are in the confguration (ON/OFF) desired to enable the output. Press the AUTOSET button and hold it down for  3 seconds until the READING red light starts fashing， then release it.The  red light (READING) fashing indicates that the microprocessor is reading and storing the state of all the inputs. Then the red light goes off and the output is enabled. Output enabling is indicated by the yellow light (STORED).

双钳口自动校准平行i气动钳夹(SZ系列)

?双作用。

?弹簧关闭；如需要时弹簧打开 。

?多种的紧固和输送选项。

?可选的磁传感器。

?FDA-H1 食品级润滑脂。

?不锈钢颚式钳。

?Double acting.

?Available with normally closed or normally open spring on

request.

?Various options for fastening and feeding.

?Optional magnetic sensors.

?FDA-H1 food-grade grease.

?Stainless steel jaws.