气动吸盘-吉玛泰克自动化-抚顺吸盘

SBMS/SBMS-E - 从模块

每个单独的从模块均可以连接单个传感器。它由内部总线连接（由主模块提供）供电，并触发两个固态继电器的换向：基于传感器输出的常开触点和常闭触点。两个选择器可用于配置传感器信号输出（PNP/2线或NPN）和逻辑（正向或反向）。该模块还有两个用于诊断的LED指示灯。

Each individual slave module enables the connection of a singlesensor.

It is powered from the internal bus connection (provided by themaster module) and triggers the commutation of two solid staterelays: a NO contact and a NC contact based on sensor output.

Two selectors are available to conffgure sensor signal output(PNP/2 wires or NPN) and logic (direct or reverse).The module also has two LED indicators for diagnostics.

真空泵 / EJ-SLG

EJ-SLG-LARGE

? 适用于集中应用

? 多个安装选项使安装和定位更容易

? G1/2' 真空端口

? 集成消音qi

? 多重真空连接

? 预装有 VACSW-3N203-G (PNP) 和 VACSW-3M203-G (NPN) 真空开关

? 提供双级和三级 EJ-LARGE 盒（EJ-LP、EJ-HF 和 EJ-HV）

典型应用

? 食品和制药行业的包装机

? 需要低重量和紧凑尺寸的情况（PKM-Delta 机器人）

? 需要高吸气流速的木材工业机器

编程单个SB8F

在对传感器盒进行编程之前，请确保有线输入处于所需配置（开/关）以启用输出。按下AUTOSET按钮并按住3秒钟，直到READING红灯开始闪烁，抚顺吸盘，然后松开。红灯（READING）闪烁表示微处理器正在读取和存储全部输入的状态。然后红灯熄灭，启用了输出。黄灯（STORED）指示启用输出。

Before programming the sensor box， make sure that the wired inputs are in the confguration (ON/OFF) desired to enable the output. Press the AUTOSET button and hold it down for  3 seconds until the READING red light starts fashing， then release it.The  red light (READING) fashing indicates that the microprocessor is reading and storing the state of all the inputs. Then the red light goes off and the output is enabled. Output enabling is indicated by the yellow light (STORED).