快速切换器-吉玛泰克自动化-夹具快速切换器

带常开//常闭继电器逻辑和钳位连接的接线盒

IP66聚苯i乙烯传感器接线盒。? 可使用标准电缆密封套定制的电缆进线/出线。? 多种型号可提供2至12个输入传感器、警告LED和接线夹。? 简单配置所连接传感器类型，所需输出类型以及使用跳线的信号处理逻辑（单个或成组）。

使用红色LED警告灯和可复位熔断器防止短路。? 可以串联多个盒子以增加可连接传感器数量。? 单个输出的zui大开关电流达1A。? 提供用于直接固定至铝型材的螺钉。

编程单个SB8F

在对传感器盒进行编程之前，快速切换器，请确保有线输入处于所需配置（开/关）以启用输出。按下AUTOSET按钮并按住3秒钟，直到READING红灯开始闪烁，手动快速切换器，然后松开。红灯（READING）闪烁表示微处理器正在读取和存储全部输入的状态。然后红灯熄灭，电动快速切换器，启用了输出。黄灯（STORED）指示启用输出。

Before programming the sensor box，夹具快速切换器， make sure that the wired inputs are in the confguration (ON/OFF) desired to enable the output. Press the AUTOSET button and hold it down for  3 seconds until the READING red light starts fashing， then release it.The  red light (READING) fashing indicates that the microprocessor is reading and storing the state of all the inputs. Then the red light goes off and the output is enabled. Output enabling is indicated by the yellow light (STORED).

3-jaw self-centring electric gripper

? Plug & p1ay user friendly gripper.

? No electricity con5umption when gripper is engaged.

? No programming required.

? Gripper retention guaranteed in event of blackout.

? Self Adapting jaws part.

? Long life Brushless motor (Brushless DC).

? Built-in motor driver.

? 24 Vdc Low Voltage Power Supply.

? M8x1， 3 poles standard connection.

? Controllable by PLC as a pneumatic valve.

? Fiber-carbon gear reduction.

? 10 milion cycle maintenance-free.

? T-slot style jaws for heavy loads.

? Weight-dimensi0n5-force best trade off.

? Rotary actuator fitting compatible.

? Optional magnetic sensors.