吕梁真空吸具-吉玛泰克自动化-真空吸具的作用

双钳口自动校准平行i气动钳夹 (DH系列)

? 具有可选弹簧的双动作（正常关闭和正常启动）。

? 长行程或者短行程(1)。

? 可以使用通孔螺丝进行前紧固(2)。

? 动力传动效i率高(1)。

? 可选电磁式或电感式的传感器(3)。

? FDA-H1 食品级润滑脂。

2-jaw self-centering pneumatic parallel gripper

(series DH)

? Double acting with optional springs (normally closed or

normally open).

? Long stroke or short stroke (1).

? P05sibility of front fastening with through screws (2).

? High efficiency force transmission (1).

? Optional magnetic or inductive sensors (3).

? FDA-H1 food-grade grease.

带端子板的传感器盒

IP66聚苯i乙烯传感器盒。? 可定制的电缆进线和出线，配有标准电缆密封套。? 2个螺钉端子，可直接连接15个输入/输出 。? 随附铝挤压型材直接固定螺钉。? 每个连接线路的zui大开关电流达1A。

IP66 polystyrene sensor box.? Customizable cable input and output with standard cable gland

2 screw terminals with direct connection of 15 inputs/outputs. ? Supplied complete with direct fxing screws for aluminum extruded profles.

Maximum switching current up to 1A for each connection line.

编程单个SB8F

在对传感器盒进行编程之前，吕梁真空吸具，请确保有线输入处于所需配置（开/关）以启用输出。按下AUTOSET按钮并按住3秒钟，真空吸具厂商，直到READING红灯开始闪烁，真空吸具的作用，然后松开。红灯（READING）闪烁表示微处理器正在读取和存储全部输入的状态。然后红灯熄灭，启用了输出。黄灯（STORED）指示启用输出。

Before programming the sensor box， make sure that the wired inputs are in the confguration (ON/OFF) desired to enable the output. Press the AUTOSET button and hold it down for  3 seconds until the READING red light starts fashing， then release it.The  red light (READING) fashing indicates that the microprocessor is reading and storing the state of all the inputs. Then the red light goes off and the output is enabled. Output enabling is indicated by the yellow light (STORED).