真空泵公司-朔州真空泵-常熟吉玛泰克自动化(查看)

夹具订制

AGG可在机械手和模具间提供精i准的中心。

注塑模具内金属嵌件安放时尤其要注意这一点。

夹具AGG...B 安装在EOAT上，钢管 AGG...C 安装在模具上。

一旦机械手向模具靠近，夹具在压力的作用下逐步向钢管靠近，真空泵公司，

并与之接触。

AGG21-B 和 AGG30-B 采用的是双动作安全弹簧，朔州真空泵，确保在压缩空

气 (NC)缺失时设备的正常运行。

AGG19-B 采用的是单动作复位弹簧(NO)。

Gripper for engagement

The AGG is used to provide a precise centering between the robot

and the mould.

This necessary when metal inserts must be p1aced in the

mould， before the p1astic injection.

The gripper AGG…-B is fitted on the EOAT， while the steel bushing

AGG…-C is fitted on the mould.

Once the robot has approached the mould， the gripper is

pressurized， thus it closes and engages the bushing.

AGG21-B and AGG30-B are double-acting with a safety spring to

keep the gripper engaged even without compressed air (NC).

AGG19-B is single-acting with reset spring (NO).

传感器

磁性传感器(可选) 通过活塞上的一个磁铁检测出操作位置。因此，大量的磁性材料和强烈的磁场可能会造成传感问题。

The operating position is detected by proximity magnetic sensors

(optional) through a magnet p1aced on the piston.

Therefore， avoid using the gripper in the vicinity of intense

magnetic ffelds or near a large mass of ferromagnetic material

as this may cause detection errors.

双钳口自动校准平行i气动钳夹 (DH系列)

? 具有可选弹簧的双动作（正常关闭和正常启动）。

? 长行程或者短行程(1)。

? 可以使用通孔螺丝进行前紧固(2)。

? 动力传动效i率高(1)。

? 可选电磁式或电感式的传感器(3)。

? FDA-H1 食品级润滑脂。

2-jaw self-centering pneumatic parallel gripper

(series DH)

? Double acting with optional springs (normally closed or

normally open).

? Long stroke or short stroke (1).

? P05sibility of front fastening with through screws (2).

? High efficiency force transmission (1).

? Optional magnetic or inductive sensors (3).

? FDA-H1 food-grade grease.