真空泵保养-真空泵-吉玛泰克自动化工程

配置和指标

?S1：实现选择输出信号的类型，PNP（P/2）或NPN（N）。

?S2：分别根据NPN或PNP选择（通过S1）实现选择内部PULLUP（PU）或PULL-DOWN（PD）电阻器。

?L1：通电时为绿色。

?L2：当常闭系列输出切换时为琥珀色（例如：全部触点打开）。

?L3：当切换常开系列时琥珀色（例如：全部触点闭合）。

?S1: enables the selection of the type of output signal，真空泵作用， PNP(P/2) or NPN (N).

?S2: enables the selection of internal PULL-UP (PU) or PULLDOWN(PD) resistors depending on the NPN or PNP selection(via S1)， respectively.

?L1: green when powered.

?L2: amber when the NC series output is switched (e.g. allcontacts open).

?L3: amber when the NO series is switched (e.g. all contactsclosed).

双钳口自动校准平行i气动钳夹(SZ系列)

?双作用。

?弹簧关闭；如需要时弹簧打开 。

?多种的紧固和输送选项。

?可选的磁传感器。

?FDA-H1 食品级润滑脂。

?不锈钢颚式钳。

?Double acting.

?Available with normally closed or normally open spring on

request.

?Various options for fastening and feeding.

?Optional magnetic sensors.

?FDA-H1 food-grade grease.

?Stainless steel jaws.

编程单个SB8F

在对传感器盒进行编程之前，真空泵厂，请确保有线输入处于所需配置（开/关）以启用输出。按下AUTOSET按钮并按住3秒钟，直到READING红灯开始闪烁，真空泵，然后松开。红灯（READING）闪烁表示微处理器正在读取和存储全部输入的状态。然后红灯熄灭，启用了输出。黄灯（STORED）指示启用输出。

Before programming the sensor box， make sure that the wired inputs are in the confguration (ON/OFF) desired to enable the output. Press the AUTOSET button and hold it down for  3 seconds until the READING red light starts fashing， then release it.The  red light (READING) fashing indicates that the microprocessor is reading and storing the state of all the inputs. Then the red light goes off and the output is enabled. Output enabling is indicated by the yellow light (STORED).