齐齐哈尔机器人抓手-机器人抓手图片-吉玛泰克(推荐商家)

ID 膨胀抓持器系列 

? 创新性气动操作手新理念。

? 向下移动 (MFD) 或向上移动 (MFU)。

? 弹性部件可以是硅氧烷或 EPDM。

? 抓手直径为 8 至 85 毫米。

? 可选鼻形锥体用于对中。

? 可选接近磁性传感器。

? 配有几个安装附件。

ID expansion grippers series 

? New concept for innovative air hands.

? Downward movement (MFD)， or upward movement (MFU).

? The elastic part can be in Silicone or EPDM.

? Grip diameters from 8 to 85 mm.

? Optional nose cones for centering.

? Optional proximity magnetic sensors.

? Several mounting accessories.

编程单个SB8F

在对传感器盒进行编程之前，机器人抓手图片，请确保有线输入处于所需配置（开/关）以启用输出。按下AUTOSET按钮并按住3秒钟，机器人吸盘抓手，直到READING红灯开始闪烁，齐齐哈尔机器人抓手，然后松开。红灯（READING）闪烁表示微处理器正在读取和存储全部输入的状态。然后红灯熄灭，启用了输出。黄灯（STORED）指示启用输出。

Before programming the sensor box， make sure that the wired inputs are in the confguration (ON/OFF) desired to enable the output. Press the AUTOSET button and hold it down for  3 seconds until the READING red light starts fashing， then release it.The  red light (READING) fashing indicates that the microprocessor is reading and storing the state of all the inputs. Then the red light goes off and the output is enabled. Output enabling is indicated by the yellow light (STORED).

? 传感器位于后部位置以及抓持区域占用空间更小的新理念。

? 可选磁性传感器 (1)。

? 只有在抓持物品时，传感器才打开。

? 带有弹簧开口的单动式驱动器。

? 高抓持力。

? 配有几个安装附件 (2)。

? 钢质颚式钳。

? FDA-H1 食品级润滑脂。

? 防止进入微小异物 (3)。

? 重型末端行程。

2-jaw self-centering angular pneumatic sprue

gripper， series DD

? New concept with retracted sensor and smaller dimensi0ns in

the grip area.

? Optional magnetic sensors (1).

? The sensor is ON only when something is gripped.

? Single acting with spring opening.

? Very high closing force.

? Several mounting accessories (2).

? Steel jaws.

? FDA-H1 food-grade grease.

? Protection against the entry of small foreign bodies (3).

? Heavy-duty end-strokes.