抓持器型材-兴安盟抓持器-常熟吉玛泰克自动化(查看)

SBMS/SBMS-E - 从模块

每个单独的从模块均可以连接单个传感器。它由内部总线连接（由主模块提供）供电，气动软体抓持器，并触发两个固态继电器的换向：基于传感器输出的常开触点和常闭触点。两个选择器可用于配置传感器信号输出（PNP/2线或NPN）和逻辑（正向或反向）。该模块还有两个用于诊断的LED指示灯。

Each individual slave module enables the connection of a singlesensor.

It is powered from the internal bus connection (provided by themaster module) and triggers the commutation of two solid staterelays: a NO contact and a NC contact based on sensor output.

Two selectors are available to conffgure sensor signal output(PNP/2 wires or NPN) and logic (direct or reverse).The module also has two LED indicators for diagnostics.

传感器

磁性传感器(可选) 通过活塞上的一个磁铁检测出操作位置。因此，大量的磁性材料和强烈的磁场可能会造成传感问题。

The operating position is detected by proximity magnetic sensors

(optional) through a magnet p1aced on the piston.

Therefore，兴安盟抓持器， avoid using the gripper in the vicinity of intense

magnetic ffelds or near a large mass of ferromagnetic material

as this may cause detection errors.

夹具订制

AGG可在机械手和模具间提供精i准的中心。

注塑模具内金属嵌件安放时尤其要注意这一点。

夹具AGG...B 安装在EOAT上，钢管 AGG...C 安装在模具上。

一旦机械手向模具靠近，夹具在压力的作用下逐步向钢管靠近，气动抓持器，

并与之接触。

AGG21-B 和 AGG30-B 采用的是双动作安全弹簧，抓持器型材，确保在压缩空

气 (NC)缺失时设备的正常运行。

AGG19-B 采用的是单动作复位弹簧(NO)。

Gripper for engagement

The AGG is used to provide a precise centering between the robot

and the mould.

This necessary when metal inserts must be p1aced in the

mould， before the p1astic injection.

The gripper AGG…-B is fitted on the EOAT， while the steel bushing

AGG…-C is fitted on the mould.

Once the robot has approached the mould， the gripper is

pressurized， thus it closes and engages the bushing.

AGG21-B and AGG30-B are double-acting with a safety spring to

keep the gripper engaged even without compressed air (NC).

AGG19-B is single-acting with reset spring (NO).